EasyDriver 步進馬達驅動器

MOM0058

EasyDriver 步進馬達驅動器非常容易使用,能夠與任何可以輸出0-5V(3V 請短路SJ2 )信號的設備配合使用。

更多資訊

NT$ 630 含稅

更多資訊

產品簡介:

EasyDriver 步進馬達驅動器非常容易使用,能夠與任何可以輸出0-5V(3V 請短路SJ2 )信號的設備配合使用。EasyDriver通過接入7-30V電壓來給馬達供電,並且可以驅動幾乎任何一款步進馬達。EasyDriver的板載穩壓IC可以設置為3.3V或者5V,可以直接與4線步進馬達以及微控制器直接連接並精確的控制步進馬達的動作。

注意:驅動器通電時,請勿連接或斷開馬達。這將導致A3967IC永久性損壞。

Description: The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver). The EasyDriver requires a 6V to 30V supply to power the motor and can power any voltage of stepper motor. The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V. Connect a 4-wire stepper motor and a microcontroller and you’ve got precision motor control! EasyDriver drives bi-polar motors, and motors wired as bi-polar. I.e. 4,6, or 8 wire stepper motors.

This EasyDriver V4.5 has been co-designed with Brian Schmalz. It provides much more flexibility and control over your stepper motor, when compared to older versions. The microstep select (MS1 and MS2) pins of the A3967 are broken out allowing adjustments to the microstepping resolution. The sleep and enable pins are also broken out for further control.

Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.

Note: This product is a collaboration with Brian Schmalz. A portion of each sales goes back to them for product support and continued development.

產品規格:

  • A3967 馬達驅動IC
  • MS1 and MS2 接腳用於控制馬達的細分(2、4、8),內定為8細分。
  • 相容任何電壓的4、6以及8線步進馬達。
  • 可調電流控制
  • 電源輸入範圍7-30V,電壓越高,高速時扭矩越高。

文件下載: