ITG-3200 三軸高精度陀螺儀

SSG0019

ITG-3200三軸高精度陀螺儀是使用ITG-3200數位輸出的三軸陀螺儀,使用I2C介面(400kHz)。

更多資訊

NT$ 1,050 含稅

更多資訊

產品簡介:

This is a breakout board for InvenSense’s ITG-3200, a groundbreaking triple-axis, digital output MEMS gyroscope. The ITG-3200 features three 16-bit analog-to-digital converters (ADCs) for digitizing the gyro outputs, a user-selectable internal low-pass filter bandwidth, and a Fast-Mode I2C (400kHz) interface. Additional features include an embedded temperature sensor and a 2% accurate internal oscillator.

The ITG-3200 can be powered at anywhere between 2.1 and 3.6V. For power supply flexibility, the ITG-3200 has a separate VLOGIC reference pin (labeled VIO), in addition to its analog supply pin (VDD) which sets the logic levels of its serial interface. The VLOGIC voltage may be anywhere from 1.71V min to VDD max. For general use, VLOGIC can be tied to VCC. The normal operating current of the sensor is just 6.5mA.

Communication with the ITG-3200 is achieved over a two-wire (I2C) interface. The sensor also features a interrupt output, and an optional clock input. A jumper on the top of the board allows you to easily select the I2C address, by pulling the AD0 pin to either VCC or GND; the board is shipped with this jumper tied to VCC. If you don’t plan on using the CLKIN pin, you can short the jumper on the bottom of the board to tie it to GND.

This breakout board is shipped as shown in the images. Note that there are two unpopulated resistors on the I2C lines, these can be added later by the customer if desired.

 

產品規格:

  • 數位輸出X-、Y-、Z-軸的角速度感測器(陀螺儀)於一顆晶片上
  • 數位可編程的低通濾波器
  • 低操作電流6.5mA可延長電池壽命
  • 寬廣VDD支援電壓,2.1V至3.6V
  • 等待電流: 5μA
  • 數位輸出溫度感測器
  • 快速模式I2C(400kHz)序列介面
  • 可選擇外部時脈32.768kHz或19.2MHz輸入來和系統時脈同步
  • 16bit ADC 轉換
  • 尺寸:0.87 x 0.72" (22.22 x 18.48mm)

 

文件下載: