MyoWare LED Shield

SSO0200

MyoWare LED Shield是設計與MyoWare肌肉傳感器配對。 藍色的10段線條圖顯示了測量信號的大小。 測量的肌肉活動越多,點亮的LED將會越高。 通過這個屏蔽層,您將看到由MyoWare肌肉傳感器和板載鋰聚合物(LiPo)電源提供的信號的直接顯示。

更多資訊

NT$ 798 含稅

更多資訊

產品簡介

This shield is likely to be the top board in a stack, so solder on some 1x3 male headers and plug into the sensor board. The power is supplied on the LED shield, but controlled by the power switch on the sensor. Once the stack is assembled, snap on some electrodes and stick the sensor on the target muscle.

The MyoWare Muscle Sensor to which this shield attaches is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle, outputting 0-Vs Volts depending on the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.

Note: The MyoWare Power Shield and the MyoWare LED Shield both provide power, but at slightly different voltages. Don’t use both of these shields at the same time.

Note: This item may take longer to process due to battery installed in the equipment and therefore does not qualify for same-day shipping policy. Additionally, these batteries can not be shipped via Ground or Economy methods to Alaska or Hawaii. Sorry for any inconvenience this may cause.

文件下載

配件