S9V11F5S6CMA開關升壓/降壓調節器可高效地產生固定的5 V（默認）或6 V（可選）輸出，無論它是高於還是低於輸入電壓，範圍可以從2 V到16 V. ：最小啟動電壓為3 V，但之後它的工作電壓為2 V，調節器還具有可用於防止電池過度放電的具有遲滯的可精確調節的低壓切斷。 當輸入電壓接近輸出電壓時，緊湊型（0.5“×0.6”）模塊可以提供高達1.5 A的典型輸出電流。
The S9V11x family of efficient switching regulators (also called switched-mode power supplies (SMPS) or DC-to-DC converters) use a buck-boost topology to convert both higher and lower input voltages to a regulated output voltage. They take input voltages from 2 V to 16 V and increase or decrease them as necessary, offering a typical efficiency of over 85% and a typical output current of up to 1.5 A. The flexibility in input voltage offered by this family of regulators is especially well-suited for battery-powered applications in which the battery voltage begins above the regulated voltage and drops below as the battery discharges. Without the typical restriction on the battery voltage staying above the required voltage throughout its life, new battery packs and form factors can be considered.
|Size:||0.5″ × 0.6″ × 0.25″1|
|Minimum operating voltage:||2 V2|
|Maximum operating voltage:||16 V|
|Maximum output current:||1.5 A3|
|Output voltage:||5 V4|
|Reverse voltage protection?:||N|
|Maximum quiescent current:||1 mA5|
|PCB dev codes:||reg20b|
|Other PCB markings:||0J10534|
Dimension diagram for the Step-Up/Step-Down Voltage Regulator S9V11x (142k pdf)Note: this dimension diagram does not apply to the smaller S9V11F5.3D model of the Step-Up/Step-Down Voltage Regulator S9V11x (4MB step)Note: this model does not apply to the smaller S9V11F5.Drill guide for the Step-Up/Step-Down Voltage Regulator S9V11x (23k dxf)
This DXF drawing shows the locations of all of the board’s holes. Note that this does not apply to the smaller S9V11F5.